Here you'll find out how to delete audio recordings and replace them with new ones. Based on Re-recording, which is also explained in the EXILIM Tips & Tricks.
JUST FOLLOW THESE STEPS
In the PLAY mode, use and to scroll through snapshots until the one whose audio you want to re-record is displayed.
Select the "PLAY" tab, select "Dubbing", and then press .
Use and to select "Delete", and then press [SET].
Press the shutter button to start audio recording.
Recording stops after about 30 seconds or when you press the shutter button. • This deletes the previous recording and replaces it with a new one.
•
Keep the microphone on the front of the camera pointed at the subject.
•
Take care that you do not block the microphone with your fingers.
•
Good recording results are not possible when the camera is too far from the subject.
•
Operating camera buttons during recording can cause button noise to be included in the audio.
•
The -Icon icon appears on the monitor screen after audio recording is complete.
•
You will not be able to record audio when remaining memory capacity is low.
•
The following types of audio recording are not supported. • Adding audio to a movie image • Adding audio to a protected snapshot
•
Audio that is re-recorded or deleted cannot be recovered. Make sure you no longer need audio before re-recording or deleting it.
and 
to scroll through snapshots until the one whose audio you want to re-record is displayed.
and 
to select "Delete", and then press [SET].
-Icon icon appears on the monitor screen after audio recording is complete.
